Frank Mendez from WaterDistillers.com shows the process for installing a Durastill Pre-Filter with fittings.

Video Notes:

00:04 Installing A Durastill Pre-Filter with Fittings

00:10 Directional Flow Arrows

00:19 Where The Source Water Comes In

00:30 Where The Water Goes Out To The Distiller

00:35 Removing the 2 End Plugs

00:49 Confirming Flow Direction

01:02 Wrenches Needed for Installation

01:10 What Comes With the Durastill Pre-filter With Fittings Kit

CLICK HERE TO PURCHASE

01:30 Turn Off Incoming Source Water AND turn off Distiller Power

01:37 Installing Brass Fittings Into The Ends Of The Filter

02:04 Hooking Up Supply Lines and Installing Brass Nut

02:43 Slide On Acetyl Plastic Sleeve with Smaller Taper Edge Facing the Fitting

02:53 Place Brass Insert Into The Tubing

02:59 Connect Supply Line to Brass Fitting on Filter

03:08 Turn On Source Water Supply And Distiller

03:14 Check for leaks and tighten fittings and nuts if necessary

03:19 Contact Frank Mendez at 612-701-7820 or frank@waterdistillers.com